Hardware Description; Front Panel - NETGEAR WAG102NA Reference Manual

NETGEAR ProSafe 802.11g Wireless Access Point WG102 Reference Manual
• Support Registration card.
Contact your reseller or customer support in your area if there are any missing or damaged parts.
See the Support Information Card for the telephone number of customer support in your area. You
should keep the Support Information card, along with the original packing materials, and use the
packing materials to repack the WG102 if you need to return it for repair. To qualify for product
updates and product warranty registrations, we encourage you to register on the NETGEAR Web
site at: http://www.NETGEAR.com.

Hardware Description

The NETGEAR WG102 ProSafe 802.11g Wireless Access Point front and rear hardware functions
are described below.

Front Panel

Figure 1-1
Viewed from left to right, the WG102 has these four status LEDs: PWR, TEST, LAN, and WLAN.
LED Description
PWR Power Indicator
Off
On
TEST Self Test Indicator
Blink
1-2
No power. If this LED does not come on with the power adapter and
cord correctly installed, see
Power is on.
Indicates self test, loading software, or system fault (if continues).
Note: This LED may blink for a minute before going off.
v1.0, July 2008
Chapter 5, "Troubleshooting.
Basic Installation and Configuration