Hitachi Koki CN16SA - 998030 Punch For CN16 Instruction Manual page 7

15. Operate power tools at the rated voltage.
Operate the power tool at voltages specified on its nameplate.
If using the power tool at a higher voltage than the rated voltage, it will result in
abnormally fast motor revolution and may damage the unit and the motor may burn
out.
16. NEVER use a tool which is defective or operating abnormally.
If the tool appears to be operating unusually, making strange noises, or otherwise
appears defective, stop using it immediately and arrange for repairs by a Hitachi
authorized service center.
17. NEVER leave tool running unattended. Turn power off.
Don't leave tool until it comes to a complete stop.
18. Carefully handle power tools.
Should a power tool be dropped or struck against hard materials inadvertently, it may
be deformed, cracked, or damaged.
19. Do not wipe plastic parts with solvent.
Solvents such as gasoline, thinner benzine, carbon tetrachloride, and alcohol may
damage and crack plastic parts. Do not wipe them with such solvents.
Wipe plastic parts with a soft cloth lightly dampened with soapy water and dry
thoroughly.
20. ALWAYS wear eye protection that meets the requirement of the latest revision of ANSI
21. Beware of sharp panel edges.
The edge of the plate just cut by the nibbler is very sharp.
Take care in not getting hurt by the sharp edge.
22. If shavings get into the machine, it will produce problems or accidents. Do not place
the machine on the shavings.
23. Shavings are hot immediately after they are cut. NEVER touch them with bare hands.
24. Preserve the power cord.
Be sure that the power cord is not abraded or cut by the sharp edge of the cut panel.
25. Definitions for symbols used on this tool
V ............ volts
Hz .......... hertz
A ............ amperes
n
.......... no load speed
o
W ........... watt
.......... Class II Construction
---/min ... revolutions or reciprocation per minute
.......... Alternating current
Standard Z87.1.
English
7