Installing Or Removing A Pci Card - Lenovo ThinkServer RD230 Hardware Maintenance Manual

Figure 25. Removing the riser card (with a PCI card installed)
6. To complete the removal procedure, go to "Completing the parts replacement" on page 87.

Installing or removing a PCI card

This section provides instructions on how to install or remove a PCI card.
Installing a PCI card
Attention
Do not open your server or attempt any repair before reading and understanding the Safety Information and the
Warranty and Support Information on the ThinkServer Documentation DVD that comes with your product, and
Guidelines. To obtain a copy of the publications, go to:
http://www.lenovo.com/support
This section provides instructions on how to install a PCI card.
To install a PCI card, do the following:
Note: Use any documentation that comes with the PCI card and follow those instructions in addition to
the instructions in this section.
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. Remove the server cover. See Removing the server cover.
3. Remove the riser card. See "Removing the riser card" on page 51.
.
Chapter 6 Installing, removing, or replacing hardware
53