Installing Or Removing A Pci Card - Lenovo ThinkServer RD240 Hardware Maintenance Manual
Hide thumbs
Also See for ThinkServer RD240:
- Software user's manual (364 pages) ,
- Hardware maintenance manual (166 pages) ,
- Benutzerhandbuch (156 pages)
Table of Contents
Advertisement
• To complete the installation, go to "Completing the parts replacement" on page 86.
Installing or removing a PCI card
This section provides instructions on how to install or remove a PCI card.
Installing a PCI card
Attention
Do not open your server or attempt any repair before reading and understanding the Safety Information and the
Warranty and Support Information on the ThinkServer Documentation DVD that comes with your product, and
Guidelines. To obtain a copy of the publications, go to:
http://www.lenovo.com/support
This section provides instructions on how to install a PCI card.
Important: Before you install optional hardware devices, make sure that the server is working correctly. If
the server is not working correctly, refer toDiagnostics for your server for detailed diagnostic information. To
obtain the publication, go to:
http://www.lenovo.com/support
To install a PCI card, do the following:
Note: Use any documentation that comes with the PCI card and follow those instructions in addition to
the instructions in this section.
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. Remove the server cover. See Removing the server cover.
3. Remove the riser card assembly. See Removing the riser card assembly.
4. Locate an appropriate PCI card slot on the riser card assembly. Then, remove the screw on the side that
secures the metal slot cover.
5. Install the PCI card into the slot on the riser card assembly (
PCI card in place (
Figure 28. Installing a PCI card into the slot on the riser card assembly
6. Reinstall the riser card assembly into the card slot on the system board. See Installing the riser card
assembly.
7. Connect any cables to the PCI card.
8. To complete the installation, go to Completing the parts replacement.
2
).
1
). Then, install the screw to secure the
.
Chapter 5
55
Replacing FRUs
Advertisement
Table of Contents
