Completing The Parts Replacement - Lenovo ThinkServer RD230 Hardware Maintenance Manual

CAUTION:
The heat sink and microprocessor might be very hot. Turn off the server and wait three to
five minutes to let the server cool before removing the server cover.
To install a new system board after a failing system board is removed, do the following:
1. Install a new system board into the chassis and align the screw holes with those in the chassis. Insert
and tighten the nine screws that secure the system board.
Figure 59. Installing the nine screws that secure the system board
2. Install the microprocessor. See "Installing the microprocessor" on page 75.
3. Install the battery. See "Installing the system board battery" on page 57.
4. Install the heat sink assembly and a memory module. See "Installing the heat sink assembly" on page
72 and "Installing a memory module" on page 39.
5. Install the adapter cards in the PCI slots. See "Installing a PCI card" on page 53.
6. Note the location of all cable connections on the system board and connect all cables. See "Locating
parts on the system board" on page 29.
7. To complete the installation, go to "Completing the parts replacement" on page 87.

Completing the parts replacement

This section provides instructions to help you complete the parts replacement and turn on your server.
To complete the parts replacement, you must reinstall the server cover, reconnect all the cables and, for
some devices, run the Setup Utility program to do further setup.
.
Chapter 6 Installing, removing, or replacing hardware
87