Kenmore 9991 - Elite 30 in. Induction Range Use And Care Manual page 11

Before Setting Oven Controls
Oven Vent Location
The oven is vented at the rear of the cooktop. When the oven is on, warm air is released
through the vents. This venting is necessary for proper air circulation in the oven and
good baking results. DO NOT block the vents. Doing so may cause cooking failures, fire
or damage to the appliance.
Arranging Oven Racks
ALWAY5 ARRANGE OVEN RACK5 WHEN THE OVEN 15 COOL (PRIOR TO OPERATING THE
OVEN). Always use oven mitts when using the oven.
To remove an oven rack, pull the rack forward until it stops. Lift up front of rack and
slide out.
To replace an oven rack, fit the rack onto the guides on the oven walls. Tilt the front of
the rack upward and slide the rack back into place.
Setting Oven
Controls
FEATURE OVERVIEW
o Before Setting Oven
Controls
o Setting Oven Controls
Setting Oven Controls
For oven settings, refer to the Electronic Oven Control Guide.
Be sure the oven is unplugged and all parts are COOL before replacing the
oven light bulb. Do not turn the oven light on during a self-cleaning cycle. High
temperature will reduce lamp life.
On some modelsaninteriorovenlight willturn on automatically whenthe ovenis
opened.
Changing Oven
Light
The oven light may be turned on when the door is closed by using the oven light switch
located on the Electronic Oven control.
On a self-cleanning oven the lamp is covered with a glass shield held in place by a wire
holder.
THIS GLASS SHIELD MUST ALWAYS BE IN PLACE WHEN THE OVEN IS IN USE.
To Replace the Light Bulb:
BE SURE OVEN IS COOL
1. Turn the power off at the main source.
2. Wear a leather-faced glove for protection against possible broken glass.
3. Replace bulb with a 40 Watt appliance bulb only.
4. For self-cleaning oven, press wire holder to one side to release glass shield, change
bulb and be sure to replace glass shield.
To adjust the oven temperature, refer to the Electronic Oven Control Guide.
Adjusting Oven
Temperature
11