Ethernet (Wired Network Only); Wired Status; Setup Wizard (Wireless Network Only); Wps (Wi-Fi Protected Setup)/Aoss™ (Wireless Network Only) - Brother HL-5450DN Network User's Manual

Control panel setup

Ethernet (wired network only)

Ethernet link mode. Auto allows the print server to operate in 1000BASE-T full duplex (For HL-6180DW(T)),
100BASE-TX full or half duplex, or in 10BASE-T full or half duplex mode by auto negotiation.
Note
• If you set this value incorrectly, you may not be able to communicate with your print server.
• For details about 1000BASE-T full duplex operation, see Gigabit Ethernet (wired network only) (For
HL-6180DW(T)) uu page 48.

Wired Status

This field displays the current wired network status.

Setup Wizard (wireless network only)

The Setup Wizard guides you through the wireless network configuration. (For more information:
uu Quick Setup Guide or Manual configuration from the control panel uu page 18.)
WPS (Wi-Fi Protected Setup)/AOSS™ (wireless network only)
If your WLAN access point/router supports either WPS (PBC
can configure the machine easily. (For more information: uu Quick Setup Guide or One push configuration
using WPS (Wi-Fi Protected Setup) or AOSS™ uu page 27.)
1
Push Button Configuration

WPS (Wi-Fi Protected Setup) w/PIN Code (wireless network only)

If your WLAN access point/router supports WPS (PIN Method), you can configure the machine easily. (For
more information, see Configuration using the PIN Method of WPS (Wi-Fi Protected Setup) uu page 29.)

WLAN Status (wireless network only)

Status
This field displays the current wireless network status.
Signal
This field displays the current wireless network signal strength.
1
) or AOSS™ (Automatic Wireless mode), you
4
4
4
4
4
4
4
4
4
38