Ethernet (Wired Network Only); Factory Reset; Set To Default (For Hl-3070Cw) - Brother HL-3040CN Network User's Manual

Ethernet (wired network only)

Ethernet link mode. Auto allows the print server to operate in 100BASE-TX full or half duplex, or in
10BASE-T full or half duplex mode by auto negotiation.
100 BASE-TX Full Duplex (100B-FD) or Half Duplex (100B-HD) and 10BASE-T Duplex (10B-FD) or Half
Duplex (10B-HD) will fix the print server link mode. This change is valid after the print server has been reset.
The default setting is Auto.
Note
If you incorrectly set this value, you may not be able to communicate with your print server.
a
Press any of the Menu buttons (+, -, OK or Back) of the control panel on your machine.
b
Press + or - to choose Network.
Press OK.
c
Press + or - to choose Wired LAN.
Press OK.
d
Press + or - to choose Ethernet.
Press OK.
e
Press + or - to choose Auto, 100B-FD, 100B-HD, 10B-FD or 10B-HD.
Press OK.

Factory Reset

The Factory Reset allows you to reset the print server back to its factory default settings. For more
information and resetting, see Reset the network settings to the factory default on page 122.

Set to Default (For HL-3070CW)

The Set to Default allows you to reset each wired or wireless network setting to the factory default.
a
Press any of the Menu buttons (+, -, OK or Back) of the control panel on your machine.
b
Press + or - to choose Network.
Press OK.
c
(For wired) Press + or - to choose Wired LAN.
(For wireless) Press + or - to choose WLAN.
Press OK.
d
Press + or - to choose Set to Default.
Press OK.
e
When OK? appears, press OK again.
Control panel features
8
8
8
8
116