Remote Control; Introduction; Remote Protocol Control Documentation - TANDBERG TT1220 Instruction Manual

4.1

Remote Control

4.1.1

Introduction

The TT1220 can be remotely controlled in a variety of ways. The basic
control methods are:
•
RS-232 control methods:
•
Over the air control methods:
Common for all control methods is that the TT1220 needs to be set up to
accept the remote control handling. Once in remote control mode, it
cannot be locally controlled unless the remote control is deactivated.
4.1.2

Remote Protocol Control Documentation

The protocols used for remote control are the TANDBERG RS-232 control
protocol and the TANDBERG Director Over-the-Air control protocol. Neither
of these protocols are described, or intended to be in the scope of this
manual.
For information about these protocols, please refer to the remote control
documentation, or contact TANDBERG to obtain this information.
NOTE...
The remote control protocols are not contained as a part of the product. An additional license fee, NDA
or other agreement with TANDBERG may be necessary to obtain the information required to control
the product remotely.
4.1.3 Configuring the Unit for Remote Control Via RS-232
For the unit to be controlled via RS-232, the RS-232 port has to be
configured to the same settings as the host controller system. The control
mode of the TT1220 also needs to be set to remote.
Instruction Manual: TT1220 Professional Receivers and Decoders
ST.TM.TT1220.4
NCompass Control and Monitoring
Third-party application (using TANDBERG RS-232 control protocol)
TANDBERG Director
Operating the Equipment Remotely
Page 4-3