Kenmore 9787 - Elite HE3 7.0 cu. Ft. Gas Dryer Installation Instructions Manual page 4

27" (69 cm) gas laundry center
Hide thumbs Also See for 9787 - Elite HE3 7.0 cu. Ft. Gas Dryer:
Table of Contents

Advertisement

Available languages

Available languages

Explosion H azard
Keep flammabme
materials a ndvapors, suchas
gasoline, away fromdryer.
Failure t o dosocanresult } ndeath, expmosion,
orfire°
You will need
A location that allows for proper exhaust installation. A gas
laundry center must be exhausted to the outdoors. See
"Venting Requirements."
A grounded electrical outlet located within 2 ft (61 cm) of
either side of the laundry center. See "Electrical
Requirements."
A sturdy floor to support the laundry center weight (laundry
center, water and load) of 500 Ibs (226.8 kg).
A level floor with a maximum slope of 1" (2.5 cm) under entire
laundry center. Clothes may not tumble properly and
automatic sensor cycles may not operate correctly if laundry
center is not level. Installing on carpet is not recommended.
A water heater set to deliver 120°F (49°C) water to the
washer.
Hot and cold water faucets located within 4 ft (1.2 m) of
the hot and cold water fill valves, and water pressure of
5-100 psi (34.5-689.6 kPa).
The laundry center must not be installed or stored in an area
where it will be exposed to water and/or weather.
Do not operate your washer in temperatures
at or below
32°F (0°C). Some water can remain in the washer and can cause
damage in low temperatures.
See "Laundry Center Care" in the
Laundry Center User Instructions for winterizing information.
Do not operate your dryer in temperatures
below 45°F (7°C). At
lower temperatures,
the dryer might not shut off at the end of an
automatic cycle. This can result in longer drying times.
Check code requirements. Some codes limit, or do not permit,
installation of the laundry center in garages, closets, mobile
homes, or sleeping quarters. Contact your local building
inspector.
NOTE: No other fuel-burning
appliance can be installed in the
same closet as a dryer.
Installation
Clearances
The location must be large enough to allow the dryer door to
open fully.
Laundry Center Dimensions
*32"
27"
(68.6cm)
*Most installations require a minimum 5" (12.7 cm) clearance
behind the dryer for the exhaust vent with elbow. See "Venting
Requirements."
Installation
spacing for recessed
area or closet installation
The following spacing dimensions are recommended
for this
laundry center. This laundry center has been tested for spacing of
0" (0 cm) clearance on the sides. Recommended
spacing should
be considered for the following reasons:
Additional spacing should be considered for ease of
installation and servicing.
Additional clearances might be required for wall, door and
floor moldings.
Additional spacing on all sides of the laundry center is
recommended
to reduce noise transfer.
For closet installation, with a door, minimum ventilation
openings in the top and bottom of the door are required.
Louvered doors with equivalent ventilation openings are
acceptable.
m
m
O
oooO
II
I
_6
_
I
_
÷ (15.20m)
46 in, 2 -
(310cm2 )
-r
/
24 in. 2 -
-...Lr,,i.__ d
_**(155cm2)
(2,5cm) (2.5cm) (81,3cm)
(12,7crn)
B
Em
c
m
r'"
27"
r'
(2,5ore)
(66,6 era)
A
A. Recessed area
B. Side view - closet or confined area
C. Closet door with vents
*Required spacing
**Rear clearance may be 1" (2.5 cm) when house exhaust system
is lined up directly with dryer exhaust.

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 9787 - Elite HE3 7.0 cu. Ft. Gas Dryer and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

9787 he3 7.0

Table of Contents