Kenmore 8875 - 24 in. Laundry Center Owner's Manual And Installation Instructions page 18

D. MAKE ELECTRICAL
CONNECTION
It is your responsibility:
• To contact a qualified electrical installer.
• To assure that the electrical installation
is adequate and in conformance with
the National Electrical Code, ANSI/
NFPA 70-latest edition and all local
codes and ordinances.
Copies of the code standards listed
above may be obtained from:
National Fire Protection Association
Batterymarch Park
Quincy, Massachusetts 02269
ELECTRICAL REQUIREMENTS
The proper electrical connection
ensures a :safe installation that
meets local code requirements.
A three-wire or four-wire, single
phase 120/240-volt, 60-Hz., AC-only,
electrical supply (or tihree-wire or
four-wire, 120/208-volt if specified on
serial/rating plate) is required on a
separate 30-ampere circuit, fused on
both sides of the line. A time-delay fuse
or circuit breaker is recommended.
This laundP.! center is manufactured with
the 3-wire, frame-grounding conductor
connected to the NEUTRAL (center) of
the wiring harness of the terminal block.
Do not have a fuse in the neutral or
grounding circuit. A fuse in the neutral
or grounding circuit could result in an
electrical shock.
Use a 4-conductor cord when the laundry
center is installed in a mobile home or
an area where local codes do not permit
grounding through the neutral.
ELECTRICAL CONNECTION OPTIONS
If Your Home Has:
3-wire electrical
receptacle
(NEMA Type 10-30R)
And _bu Will Be GoTo
Connecting To: Page
A U.L.-listed, 120/240-volt
minimum, 30-amip., dryer
power supply cord.*
3-wire direct 0
A fused disconnect or
circuil breaker box.*
4-wire electrical
receptacle
(NEMA Type 14-30R)
A U.L.-listed, 120!240-volt
minimum, 30-amp., dryer
power supply cord.
4-wire direct
J
A fused disconnect or
circuit breaker box.
*If local codes do not permit the connection of a frame-grounding conductor
to the neutral wire, see the instructions on page 23.
19-1.
21 - II.
24 - III.
27 - IV.
18