Kenmore 8875 - 24 in. Laundry Center Owner's Manual And Installation Instructions page 60

Mostlaundering problems areeasily
solvedifyouunderstand t hecause.
Checkthesetablesforcommon laundry
andwasher problems. I 1: youneed
furtherassistance, seepage68.
Problem Possible Cause Solution
Washer Leaks Household plumbing is leaking. Repair plumbing.
Inlet hoses not tight. Tighten hoses
(see "INSTALLAI-ION'_ Sections F & G).
Inlet hose washers not Reseat washers
properly seated. (see "INSTALLAI-ION'_ Section F).
Drain hose not properly Clamp drain hose
clamped or is off. (s_e "INSTALLA-I-ION'_ S ection E).
Drain is clogged. Remove drain clogs. Laundry tub,
standpipe, or floor drain must be able to
h_.ndle 17 gallons of water per minute.
Tub moved forward during Ensure tub is centered before
unloading, causing water starting washer.
to deflect off of tub ring.
Laundry center not level Ensure leveling legs are installed.
causing water to deflect off Level laundry center
of tub ring. (see "INSTALLATION'_ Section I).
Load is unbalanced. Spray Redistribute the load.
rinses are deflecting off of load.
Washer is overloaded. Fills Reduce load size.
or spray rinses are deflecting
off of load.
Won't Drain/ Drain hose is kinked 3traighten or unplug hose
Won't Spin/ or clogged. (see "INSTALLAIION'_ Section E).
Wet Loads
Correct operation of ,&tier a wash or rinse, the washer will
neutral drain, drain without spinning. After draining,
the spinning begins.
Lid is open. Close the lid.
Drain hose is more than l_owerdrain hose
96 inches above floor. (see "INSTALLATION_Section E).
Too much detergent-- Use less detergent.
excessive sudsing.
Wrong cycle for load Choose a cycle with a higher spin
being washed, speed (see "OPERATION").
60