Kenmore 8875 - 24 in. Laundry Center Owner's Manual And Installation Instructions page 33

I. LEVEL LAUNDRY CENTER J. CONNECT EXHAUST
Leveling your laundry center
properly prevents excessive
noise and vibration.
STEP 1. Check levelness of the
laundry center by placing a level on
top of the washer, first side-to-side;
then front-to-back.
STEP 2, If laundry center is not level,
"prop up the front of the laundry center
and adjust the front legs up or down
as necessary. Lower laundry center.
Repeat STEP 2 until the laundry center
is level.
A properly exhausted laundry center
will give you the shortest drying time,
lower your utility bill, and extend the
life of the laundry center.
Fire Hazard
Use a heavy metal vent.
Do not use a plastic vent.
Do not use a metal foil vent.
Failure to follow these instructions
can result in death or fire.
WARNING: To reduce the risk of fire,
this dryer must be exhausted outdoors.
• Use a heavy metal vent.
• Do not use a plastic vent.
• Do not use a metal foil vent.
° Do not exhaust laundry center into
a chimney, a wall, a ceiling, or a
concealed space of a building.
• The diameter of the heavy metal vent
must be 4 inches.
• Do not use an exhaust hood with a
magnetic latch.
• If using an existing exhaust system,
disconnect vent from the laundry center
and clean one section at a time until you
reach the exhaust hood. To clean out
lint, you can use the hose attachment
on your vacuum or, use a pole or wire
with a feather duster or rag attached.
• Make sure exhaust hood is not plugged
with lint. Follow the instructions in this
section to reinstall your vent system.
33