Table of Contents
Advertisement
LAN Phone 101 User Manual Guide
2.
User Line Number (mandatory)
3.
Ring Configuration
4.
Indicate Forward Type
5.
Message Box
6.
Phone Address Book
Note: LCD Panel of LAN Phone 101 is operated manually by moving or on the keypad.
Press OK to enter separate configuration menu. Press C to go back to the main menu.
(2)New version of Hardware(5.x):
1.When power on the LAN Phone 101, the LCD screen shows as below.
2.Wait around one minute until the LAN Phone 101 finishes application program initialization.
3.User can see flashing greeting as below:
System Initializing..............
4.Then LAN Phone get into standby mode:
GK
The main LCD screen would be shown as similar as above. The GK word means the LAN
Phone 101 is in GateKeeper Mode, and when LAN Phone is connected to SNTP server, on
LCD will show current time from SNTP server.
5. After pressing the PSTN button, the GK word will be replaced by PSTN. Then LAN Phone is
in PSTN Mode. Please notice that in PSTN mode user must plug PSTN line in RJ-11 port.
PSTN
Press or to enter into Configuration Mode and then press OK Bottom.
There are 6 selections for configuration.
Copyright (c) 2002 WellTech Computer Corporation
IP-Phone
10:10:10 AM
IP-Phone
10:10:10 AM
12
Document Ver. 1.6
LAN Phone Ver 111a/501a
Advertisement
Table of Contents
