Turn the bulb socket 1/4
turn counter-clockwise,
while pressing it firmly.
Remove the wire connector
from the bulb by lifting the
lock tab and pulling it away
from the plastic base.
To reassemble, attach the wire connector (A) to the
plastic base making sure the lock tab (B) is over the lock
(C). Install the bulb by putting the small tab (D) into the
small notch in the lamp (E). Turn the bulb socket 1/4
turn clockwise to lock into place. When reinstalling the
headlamp assembly into the headlamp mounting panel,
make sure the tab is properly engaged in the panel slot.
Taillamp Bulb Replacement
Open the trunk. On either
side of the rear of the trunk
are two plastic nuts.
Remove only the side that
you need to access. Pull the
carpet back away from the
rear area. The taillamp,
sidemarker and back-up
lights can now be accessed.
257