Using Reset - Binatone iDECT V2 System Manual

iDect_V2_IFU_master.book Page 34 Friday, April 4, 2008 4:05 PM
Custom settings
Note
■ If the PIN has been changed from the default 0000
already, at step 4 it will display
to key in the current PIN and press MENU/OK,
before the display shows

Using reset

The Reset command will restore the iDECT V2 to its
factory default settings. Use Reset with care because it
will clear the Phonebook, Caller ID and Redial
memories.
1
To reset all
M
settings to
their defaults:
2
d
3
M
u
4
M
5 .
M
6
M
7
B
f
34
Enter PIN
Enter New
Press the MENU/OK button
The display shows Main Menu
!
D
Press the button THREE times
! The display shows Main Menu
Press the MENU/OK button then the
ONCE
! Display shows Advanced Set
Press the MENU/OK button
! Display shows Enter PIN if your PIN code has
been changed from the default 0000. (If the PIN
is still 0000 the display shows
you go to step 6.).
Key in the current PIN and press the MENU/
OK button
Display shows Confirm Reset?
!
Press the MENU/OK button
! You will hear a long confirmation beep.
Use the BACK button to exit the menu or press
HANG UP to go to standby mode
and you need
PIN.
> Phonebook
> Advanced Set
U
button
> Reset
Confirm Reset? and