Installing A Simple Swap Serial Ata Hard Disk Drive - IBM 8836 - Eserver xSeries 306 Maintenance And Troubleshooting Manual

Installing a simple swap Serial ATA hard disk drive

Complete the following steps to install a simple swap Serial ATA hard disk drive.
Note: If you have only one hard disk drive, install it in the left drive bay.
Hard disk drive
1. Read the safety information beginning on page 83 and "Installation guidelines"
2. Turn off the server and peripheral devices, and disconnect the power cord and
3. Press the release tabs on the bezel, and pull the bezel away from the server.
4. Slide the drive into the server until the drive connects to the backplane.
5. Reinstall the bezel.
If you have other options to install, do so now. Otherwise, go to "Completing the
installation" on page 41.
on page 27.
all external cables.
SATA hard disk
drive connector
Chapter 4. Installing options
35