Installing A Hard Disk Drive; Installing A Simple-Swap Serial Ata Hard Disk Drive - IBM System x3250 User Manual
Types 4364 and 4365
Hide thumbs
Also See for System x3250:
- Problem determination and service manual (142 pages) ,
- Installation and user manual (106 pages) ,
- Installation manual (76 pages)
Table of Contents
Advertisement
7. Press the Remote Supervisor Adapter II SlimLine firmly into the connector and
8. If an adapter is installed in expansion slot 1 on the riser-card assembly, remove
9. Carefully align the riser-card assembly with the guides on the rear of the server
See the documentation that comes with the Remote Supervisor Adapter II SlimLine
for information about installing the firmware and configuring the adapter. Create a
backup copy of the configuration so that if you have to replace the adapter in the
future, you can restore the configuration.
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 32.
Installing a hard disk drive
Locate the documentation that comes with the hard disk drive and follow those
instructions in addition to the instructions in this chapter.
Attention:
cover is in place and fully closed whenever you install or remove a hard disk drive.
Installing a simple-swap Serial ATA hard disk drive
Attention:
power from the server before you remove or install a simple-swap hard disk drive.
To install a simple-swap Serial ATA hard disk drive, complete the following steps.
Note: If you have only one hard disk drive, install it in the left drive bay.
Hard disk
drive assembly
Attention:
cover is in place and fully closed whenever you install or remove a hard disk drive.
24
IBM System x3250 Types 4364 and 4365: User's Guide
make sure that all tabs on both mounting brackets secure the adapter in place.
Attention:
Incomplete insertion might cause damage to the server or the
adapter.
it.
and with the riser-card connectors on the system board; then, press down on
the assembly. Make sure that the riser-card assembly is fully seated in the
riser-card connectors on the system board.
To avoid damage to the hard disk drive connectors, make sure that the
Simple-swap hard disk drives are not hot-swappable. Disconnect all
To avoid damage to the hard disk drive connectors, make sure that the
SATA hard disk
drive back plate
Filler panel
Advertisement
Table of Contents
