Complete the following steps to replace a hot-swap power supply:
1. Review the safety information beginning on page 131 and "Installation
2. Press the orange release lever on the selected power supply; then, pull the
3. Make sure the power-supply handle is in the open position; then, slide the
4. If the server is not on, turn on the server.
5. Verify that the dc power LED and the ac power LED on the power supply are lit,
68
IBM xSeries 225 Type 8647: Hardware Maintenance Manual and Troubleshooting Guide
guidelines" on page 37
power supply out of the bay and set it aside.
power supply all the way into the chassis before placing the power-supply
handle into the locked position.
indicating that the power supply is operating properly.