Table of Contents
Advertisement
10. Replace any adapters that were removed in step 5 (see "Installing an adapter"
11. If you have other options to install, do so now.
12. Replace the air baffle and air flow guide.
92
IBM xSeries 225 Type 8647: Hardware Maintenance Manual and Troubleshooting Guide
7. Remove the adapter from the static-protective package. Move the adapter
directly from the static-protective package to the adapter slot. Avoid touching
the components and gold-edge connectors on the adapter.
8. Install the adapter.
a. Turn the adapter so that the adapter keys align correctly with the mini-PCI
type III connector (PCI2) on the system board.
Attention:
To avoid breaking the retaining clips or damaging the
connectors, handle the clips gently.
b. Insert the adapter into the connector at a slight angle and then press it
toward the system board until the retaining clips snap into the closed
positions. Also, make sure that the two stand-offs on the system board
come through their holes in the video adapter and lock it in place.
Note: If there is a gap between the adapter and the retaining clips, the
adapter has not been properly installed. In this case, open the
retaining clips and remove the adapter; then, reinsert the adapter.
You might need to disengage the locking clips on the two stand-offs
to remove the adapter.
Attention:
Be certain that the adapter is correctly seated in the expansion
slot before you turn on the server. Incomplete installation of an adapter might
damage the system board or the adapter.
9. Connect required cables to the adapter. Route cables so that they do not block
the flow of air from the fans.
on page 46).
Advertisement
Table of Contents
Troubleshooting
