Removing The Bezel - IBM 8646 - Eserver xSeries 220 Hardware Maintenance Manual

1. Review the information in "System reliability considerations" on page 44.
2. Turn off the server and all attached devices and disconnect power cords and
3. If necessary, unlock the server cover.
4. Pull out on the cover-release latch near the rear of the server cover; then, slide
5. For a tower model, rotate the stabilizing feet on the bottom of the server, and

Removing the bezel

The following illustration shows how to remove the bezel from the server.
Note: The illustrations in this document might differ slightly from your hardware.
Do the following to remove the bezel:
1. Review the information in "System reliability considerations" on page 44.
2. Turn off the server and peripheral devices and disconnect all power cords and
3. Remove the side cover (see "Removing the side cover" on page 45).
4. Press the bezel-release latch at the top of the server to disconnect the top of the
5. Release the two tabs at the top edge of the bezel and pull the top of the bezel
6. Pull the bezel up to release the two tabs at the bottom edge of the bezel. Store
46
Hardware Maintenance Manual: xSeries 220 Type 8646
then all external cables.
the cover toward the rear of the server and remove it.
Attention: For proper cooling and airflow, replace the cover before turning
on the server. Operating the server for extended periods of time (over 30
minutes) with the cover removed might damage server components.
place the server on its side to install or remove components.
then all external cables.
bezel from the server.
slightly away from the server.
the bezel in a safe place.