Rear Cushion Installation; Rear Swing Arm Removal; Rear Swing Arm Disassembly - DAELIM HISTORY 125 Service Manual

REAR WHEEL/BRAKE/SUSPENSION/REAR SWING ARM

REAR CUSHION INSTALLATION

● Install the spring, stopper rubber to the damper
component.
NOTE
·Install the spring with its narrow pitch side facing
upward.
● Apply thread locking agent to the hex nut, and install
the rear cushion compressor attachment on the damper
rod.
● Fix the upper metal, and tighten the hex nut.
TORQUE VALUE : 3.0~4.5kgf·m
TOOLS : REAR CUSHION COMPRESSOR
REAR CUSHION COMPRESSOR ATTACHMENT
● Install the rear cushion.
● Tighten the top and bottom of the cushion with bolts.
TORQUE VALUE : UPPER SIDE 3.5~4.5kgf·m
LOWER SIDE 3.5~4.5kgf·m
● Install the luggage box. (⇨4-4 )
REAR SWING ARM
REMOVAL
● Remove the EX. muffler. (⇨4-12 )
● Remove the rear brake caliper. (⇨14-6 )
● Loosen the flange bolt securing the RH. crank case
cover.
● Loosen the rear axle U-nut.
● Remove the rear swing arm.
DISASSEMBLY
● Disassemble the rear wheel outside collar from the rear
swing arm.
● Disassemble the oil seal (28×42×7) and radial ball
bearing (6302UU).
● Install in the reverse order of removal.
TORQUE VALUE
- REAR WHEEL AXLE NUT : 6.0~8.0 kgf·m
13-8
REAR CUSHION COMPRESSOR
REAR CUSHION COMPRESSOR ATTACHMENT
FLANGE BOLT
REAR SWING ARM
REAR
CUSHION
AXLE U-NUT