Ip Address Filtering - TP-Link TL-WR702N User Manual

Enable Firewall - the general firewall switch is on or off.
Enable IP Address Filtering - set IP Address Filtering is enabled or disabled. There are two
default filtering rules of IP Address Filtering, either Allow or Deny passing through the router.
Enable Domain Filtering - set Domain Filtering is enabled or disabled.
Enable MAC Filtering - set MAC Address Filtering is enabled or disabled. You can select the
default filtering rules of MAC Address Filtering, either Allow or Deny accessing the router.
5.9.2

IP Address Filtering

The IP address Filtering feature allows you to control Internet Access by specific users on your
LAN based on their IP addresses. The IP address filtering is set on this page:
To disable the IP Address Filtering feature, keep the default setting, Disabled. To set up an IP
Address Filtering entry, click Enable Firewall and Enable IP Address Filtering on the Firewall
page, and click the Add New... button. The page "Add or Modify an IP Address Filtering entry"
will appear shown in Figure 5-36:
To create or modify an IP Address Filtering entry, please follow these instructions:
Figure 5-35 IP address Filtering
Figure 5-36 Add or Modify an IP Address Filtering Entry
TL-WR702N 150Mbps Wireless N Nano Router
- 84 -