TP-Link TL-WR702N User Manual page 27

3.2.4 Bridge Mode
When you choose Bridge on Working Mode page in Figure 3-5 , take the following steps:
1. Click Next, and then Wireless Repeater page will appear as shown in Figure 3-17.
SSID - Enter a string of up to 32 characters. The same name of SSID (Service Set
Identification) must be assigned to all wireless devices in your network. The default SSID is
set to be TP-LINK_XXXXXX (XXXXXX indicates the last unique six numbers of each
Router's MAC address). But it is recommended strongly that you change your networks
name (SSID) to a different value. This value is case-sensitive. For example, TEST is NOT
the same as test.
TL-WR702N
Figure 3-16 Quick Setup - Finish
Figure 3-17 Quick Setup - Wireless Bridge
- 21 -
150Mbps Wireless N Nano Router