TP-Link TL-WR702N User Manual page 20

Wireless Radio - Enable or disable the wireless radio choosing from the pull-down list.
SSID - Enter a string of up to 32 characters. The same name of SSID (Service Set
Identification) must be assigned to all wireless devices in your network. The default
SSID is set to be TP-LINK_XXXXXX (XXXXXX indicates the last unique six numbers of
each Router's MAC address). But it is recommended strongly that you change your
networks name (SSID) to a different value. This value is case-sensitive. For example,
TEST is NOT the same as test.
Region - Select your region from the pull-down list. This field specifies the region where
the wireless function of the Router can be used. It may be illegal to use the wireless
function of the Router in a region other than one of those specified in this field. If your
country or region is not listed, please contact your local government agency for
assistance.
Channel - This field determines which operating frequency will be used. The default
channel is set to Auto. It is not necessary to change the wireless channel unless you
notice interference problems with another nearby access point.
Mode - Select the desired mode. The default setting is 11bgn mixed.
• 11b only - Select if all of your wireless clients are 802.11b.
• 11g only - Select if all of your wireless clients are 802.11g.
• 11n only- Select only if all of your wireless clients are 802.11n.
TL-WR702N
Figure 3-6 Quick Setup - Wireless AP
- 14 -
150Mbps Wireless N Nano Router