TP-Link TL-WR702N User Manual page 23

The Router supports three popular ways PPPoE, Dynamic IP and Static IP to connect to the
Internet. To make sure the connection type your ISP provides, please refer to the ISP. Make sure
the cable is securely plugged into the WAN port before detection.
PPPoE - For this connection, you will need your account name and password from your ISP.
If you have applied ADSL to realize Dial-up service, you should choose this type. Under this
condition, you should fill in both the User Name and Password that the ISP supplied. Please
note that these fields are case-sensitive.
Dynamic IP - Your ISP uses a DHCP service to assign your Router an IP address when
connecting to the Internet.
When the Router connects to a DHCP server, or the ISP supplies you with DHCP connection,
please choose this type. The Router gets the IP address automatically from the DHCP server
or the ISP if you choose Dynamic IP, and then the next screen will appear as shown in
Figure 3-16. Then you can go on with the wireless configuration.
Static IP - This type of connection uses a permanent, fixed (static) IP address that your ISP
assigned.
In this type, you should fill in the IP address, Subnet Mask, Default Gateway, and DNS IP
address manually, which are specified by your ISP.
TL-WR702N
Figure 3-10 Quick Setup - WAN Connection Type
Figure 3-11 Quick Setup - PPPoE
150Mbps Wireless N Nano Router
- 17 -