Quick Setup; Working Mode - TP-Link TL-WR702N User Manual

• Received (Packets) - Traffic that counted in packets has been received out from the WAN
port.
System Up Time - The length of the time since the Router was last powered on or reset.
Click the Refresh button to get the latest status and settings of the Router.

5.3 Quick Setup

Please refer to Section 3.2: "Quick Installation Guide."

5.4 Working Mode

The Router supports five operation mode types: AP, Router, Repeater, Bridge and Client.
Please select one your want. Click Save to save your choice, which is shown as Figure 5-3.
AP - The wireless access point mode.
Router - The wireless Router Mode. In this mode, the device enables multi-user to share
Internet via DSL/Cable Modem. The only wired port works as WAN.
Repeater - The wireless Repeater Mode. It could extend the range of wireless network.
Bridge - The wireless Bridge Mode. It could communicate with another wireless network.
Client - The Client Mode. The computer connected by Ethernet could get access to an AP by
Client mode.
Click OK in the following screen and then the Router will reboot and to work on Router Mode.
TL-WR702N
Figure 5-3 Wireless Working Mode Settings
Figure 5-4
- 54 -
150Mbps Wireless N Nano Router