Table of Contents
Advertisement
Recording a remote session
Automatically recording a remote session
You can record a session for later playback at any point during the remote session.
You can save the session in a new record file or add the recording to the end of
an existing record file.
To record a remote session
1
In the Session Manager window, on the left navigation bar, under Remote
Control click Start/Stop Session Recording.
2
Do one of the following:
To add the recording to the end of an existing record file, select the file
(*.rcd) that you want to use.
To create a new file, type the file name.
3
Click Save.
Actions that you perform on the host computer after this point are recorded
in the file.
See
"Replaying a recorded session"
4
When you are done recording, click Start/Stop Session Recording.
You can configure a remote connection item to automatically record a session
upon connection. Depending on the frequency and duration of the sessions on
the host computer, the size of the record file can become large.
To automatically record a remote session
1
In the Symantec pcAnywhere window, on the left navigation bar, click
Remotes.
2
In the right pane, right-click the connection item that you want to modify,
and then click Properties.
3
In the Remote Properties window, on the Remote Control tab, under Remote
session recording, check Record session in file for later playback.
4
Type a name and path for the file, or browse to the location of an existing
.rcd file.
5
Click OK.
Recording starts immediately after you connect to the host computer.
See
"Replaying a recorded session"
Monitoring and recording sessions
About recording and replaying sessions
on page 244.
on page 244.
243
Advertisement
Table of Contents
