Configuring Workflow 7.0 - Symantec ALTIRIS WORKFLOW 7.0 - INSTALLATION AND CONFIGURATION GUIDE V1.0 Configuration Manual

34 Installing Workflow 7.0

Configuring Workflow 7.0

Configuring Workflow 7.0
13 On the Workflow Persistence step, click a persistence option.
Note: If you are currently running Workflow 6.5, make sure you use the same
persistence settings for Workflow 7.0.
If you install Workflow 7.0 with different persistence settings than your
currently running 6.5 version, all current tasks will become non-functional.
See Upgrading from Workflow 6.5"
See Determining a project's persistence setting"
If you cannot determine your persistence setting from Workflow 6.5, use
Exchange for your Workflow 7.0 installation.
14 On the Symbus ORM step, configure the ORM.
15 After you have passed the system check, click Next and then click Install.
You will be notified when the installation has completed successfully.
Once you have installed Workflow 7.0, you are ready to configure it.
See About Workflow 7.0"
See Installing Workflow Solution through Symantec Installation Manager"
on page 21.
See Downloading the Workflow installer through the Symantec Management
Console " on page 22.
See Installing Workflow Server"
See Installing Workflow Designer"
See Licensing Workflow Server, Workflow Designer, and Process Manager"
on page 37.
See Migrating links from Notification Server 6.5 to Symantec Management
Platform 7.0" on page 35.
Configuration involves the following steps:
on page 15.
on page 9.
on page 27.
on page 29.
on page 17.