Symantec ALTIRIS WORKFLOW 7.0 - INSTALLATION AND CONFIGURATION GUIDE V1.0 Configuration Manual page 25

Step Action
Step 4 Test the configuration
Installing with separate background processing (continued)
Table 2-1
Adding connection settings between the primary and secondary
servers
After you have installed Workflow 7.0 in a separate background processing
configuration, edit the task tray settings on the primary server (main Workflow
server) and the secondary server (background processing server).
To add connection settings
1 On the primary server, add the secondary server to the task tray connection
settings.
On the primary server, double-click the task tray application.
Click Add.
Configure the settings for your secondary server, and then click OK.
2 On the secondary server, add the primary server to the task tray connection
settings.
On the secondary server, double-click the task tray application.
Click Add.
Configure the settings for your primary server, select
LogicBase_ProcessManager for the server role, and then click OK.
3 Click the Default Server drop-down list and click the primary server.
Note: Because the default polling interval is set to twenty-four hours, the
background processing may not start immediately. If you want it to start
immediately, reduce the polling interval (Workflow Server Configuration >
AutoTriggerInfo > Polling Service List Interval Minutes). Remember to
reset the polling intverval after background processing has registered.
Description
Create and publish a test project to test the separate background
processing.
See Testing a separate background processing configuration"
on page 26.
Installing Workflow 7.0
Possible installation configurations
25