Symantec ALTIRIS WORKFLOW 7.0 - INSTALLATION AND CONFIGURATION GUIDE V1.0 Configuration Manual page 18

18 About Workflow 7.0 and installation
About installing Workflow 7.0
Persistence option
LogicBase.Components.Default.ExchangeAdapters.
LogicBaseExchangeWorkQueue
LogicBase.Core.Workflow.FileSystemAdapters.
FileSystemWorkQueue
LogicBase.Core.Models.Workflow.InMemoryWorkQueue
LogicBase.Core.Workflow.SQLServerAdapters.
SQLServerWorkQueue
Persistence options (continued)
Table 1-7
Your projects are probably set to use
LogicBase.Components.Default.ExchangeAdapters.LogicBaseExchangeWorkQueue.
If this is the case, you can determine whether the exchange is set to file-based or
SQL-based persistence in the Configuration and Logging Tool.
See To determine the default persistence setting in the Configuration and Logging
Tool" on page 18.
If any of your projects use a persistence setting other than
LogicBase.Components.Default.ExchangeAdapters.LogicBaseExchangeWorkQueue,
you should version them to avoid losing process data.
See Versioning a process"
To determine the default persistence setting in the Configuration and Logging Tool
1 Open the Configuration and Logging Tool.
Start > Programs > Altiris > Workflow Designer > Tools > Configuration
and Logging Tool.
2
Click the Exchange Configuration tab.
Description
Uses Exchange for persistence. This is the most common
persistence setting. This setting uses either file-based or
SQL-based persistence over Exchange.
For information on determining whether this setting uses
file-based or SQL-based persistence, see the following
section:
See To determine the default persistence setting in the
Configuration and Logging Tool"
The Workflow 7.0 equivalent of this is Exchange
(file-based) or SQL-based persistence. You can set this
when you install Workflow 7.0.
Uses direct file-based persistence.
There is no Workflow 7.0 equivalent of this setting.
Uses internal Workflow memory.
There is no Workflow 7.0 equivalent of this setting.
Uses direct SQL-based persistence.
There is no Workflow 7.0 equivalent of this setting.
on page 19.
on page 18.