About Installing Workflow 7.0 - Symantec ALTIRIS WORKFLOW 7.0 - INSTALLATION AND CONFIGURATION GUIDE V1.0 Configuration Manual

About installing Workflow 7.0

Where to get more information
Table 1-4
Information source
Workflow SWAT
Symantec Management Platform 7.0 Release
Notes
Altiris 7.0 Planning and Implementation
Guide
Installing the Symantec Management
Platform 7.0 products
Knowledge Base
Symantec Connect
Depending on whether you are installing Workflow for the first time, the
installation process has three main steps: installing through Symantec Installation
Manager, downloading the installer through Symantec Management Console, and
running the installer.
See Installing Workflow for the first time"
Workflow 7.0 has only one installer for numerous pieces. While installing you
can click which pieces of Workflow 7.0 you want to install.
See About Workflow 7.0"
Although you have a lot of flexibility with how you install Workflow 7.0, every
installation must conform to the following parameters:
Workflow Solution must be installed in Symantec Installation Manager.
Workflow Server must be installed on every computer running Workflow 7.0
(this is done automatically with every Workflow install).
Although Workflow Server always gets installed with Workflow Designer or
Process Manager, you should designate a server as the production Workflow
server and install Workflow Server on that server. This creates one central location
for all production-ready workflows.
You do not have to install either Workflow Designer or Process Manager when
you install Workflow Server. For a typical production environment, install Process
Manager only on a central server, and install Workflow Designer only on design
Location
www.workflowswat.com
https://.kb.altiris.com
https://.kb.altiris.com
https://.kb.altiris.com
https://.kb.altiris.com
http://www.symantec.com/connect/
on page 14.
on page 9.
About Workflow 7.0 and installation
About installing Workflow 7.0
13