Upgrading From Workflow 6.5 - Symantec ALTIRIS WORKFLOW 7.0 - INSTALLATION AND CONFIGURATION GUIDE V1.0 Configuration Manual

Upgrading from Workflow 6.5

Step Action
Step 1 Backup your projects
Process for installing Workflow 7.0 (continued)
Table 1-5
Step Action
Step 3 Install Workflow
Refer to the following steps if you are upgrading Workflow 6.5 to Workflow 7.0.
If you are installing Workflow for the first time, see the following section:
See Installing Workflow for the first time"
You can disrupt currently-running Workflow 6.5 processes by installing Workflow
7.0 if you do not keep the same persistence settings. Ideally, you should use the
same persistence settings for Workflow 7.0 that you used for Workflow 6.5. During
installation you can set the persistence setting for Workflow 7.0. If the persistence
setting in Workflow 6.5 is not supported in Workflow 7.0, version your projects
so you do not overwrite the currently-running processes.
See Versioning a process"
If you do not know what persistence settings your current version of Workflow
is using, refer to the following section:
See Determining a project's persistence setting"
Symantec recommends using the following steps to upgrade your
currently-running processes from Workflow 6.5 to Workflow 7.0:
Process for upgrading currently-running processes
Table 1-6
on page 14.
on page 19.
Description
Create packages for all your projects, and store these packages
on a safe directory.
For more information on creating a project package, see the
Workflow 7.0 User's Guide.
www.alitis.com/support/documentation.aspx
About Workflow 7.0 and installation
About installing Workflow 7.0
Description
Run the Workflow installer to install
Workflow on your local computer.
There is only one installer for all the
pieces of Workflow.
See Installing Workflow Server"
on page 27.
See Installing Workflow Designer"
on page 29.
on page 17.
15