Networking Node - Symantec ALTIRIS REAL-TIME SYSTEM MANAGER 7.0 SP2 - V1.0 Manual

Networking node

Pages under the Memory node
Table 5-15
Page
Cache Memory
Logical Memory Configuration
Physical Memory
This node contains networking items.
Pages under the Networking node
Table 5-16
Page
Intel AMT Network
Filtering
Intel AMT Network
Settings
IP Route Table
About Real-Time System Manager pages
Description
Displays cache memory information.
Displays logical memory configuration information.
Displays physical memory information.
Description
See "Filtering network traffic "
This page is available only if Real-Time System Manager
detects that the target computer is configured to use Intel
AMT.
The page lets you change the network settings that the Intel
AMT device uses. We recommend that you configure the Intel
AMT device to obtain an IP address automatically. Dynamic
IP address lets you make sure that the IP of the Intel AMT
device is always the same as the IP of the operating system.
The same IP lets you manage the computer using both WMI
and Intel AMT interfaces simultaneously.
Warning:
Be careful when configuring the VLAN value. If
the value is incorrect, the Intel AMT devices will not be
accessible.
Displays the information that concerns the routing of
network data packets.
Internet packets are usually sent to a gateway and local
packets are routed directly by the client computer. You can
use this information to trace the problems that are associated
with misrouted packets and direct a computer to a new
gateway as necessary. This class is only applicable to IP4 and
does not address IPX or IP6. The class is intended to provide
the same information that is shown when you type the route
print command at the command prompt.

Networking node

on page 37.
55