Checking the LEDs on Lightweight Access Points
Checking the LEDs on Lightweight Access Points
If your lightweight access point is not operating properly, check the LEDs on the back panel. You can
use them to quickly assess the unit's status.
Figure 5-1
R
S
The Install LED is not used on the 1300 series lightweight access points.
Note
Cisco Aironet 1300 Series Wireless Outdoor Access Point/Bridge Hardware Installation Guide
5-2
LEDs
R
S
I
Radio LED
Status LED
Chapter 5
Figure 5-1
shows the access point LEDs.
E
E
Ethernet LED
I
Install LED
Troubleshooting Lightweight Access Points
OL-5048-06