Cisco AIR-BR1310G-A-K9 - Aironet 1310 Outdoor Access Point/Bridge Hardware Installation Manual page 95

Appendix C Access Point Specifications
Table C-1 Access Point, Power Injector, and Power Module Specifications (continued)
Category
Data rates
Non-overlapping
channels
Antenna
Environmental air space The access point/bridge and pow er i nj ect or pr ovi de adequat e f i r e r es i s t ance and l ow s m oke- pr oduci ng
Safety
OL-5048-06
Access Point
IEEE 802.11b/g-compliant radio:
1, 2, 5.5 and 11 Mbps
6, 9, 12, 18, 24, 48, and 54 Mbps
(Depending on the regulatory domain in which the
access point/bridge is installed)
3
Integrated antenna
13-dBi patch array
Some external antennas:
5.2-dBi omnidirectional
12-dBi omnidirectional
9-dBi patch
10-dBi yagi
13.5-dBi yagi
14-dBi sector
21-dBi dish
(Depending on the regulatory region)
char act er i s t i cs s ui t abl e f or oper at i on i n a bui l di ng' s envi r onm ent al ai r s pace, s uch as above s us pended
cei l i ngs , i n accor dance w i t h Sect i on 300- 22( C) of t he N at i onal El ect r i cal Code ( N EC) and Sect i ons
2- 128, 12- 010( 3) and 12- 100 of t he Canadi an El ect r i cal Code, Par t 1, C22. 1.
The power module is not tested to UL 2043 and should not be placed in a building's
Caution
air-handling spaces, such as above suspended ceilings.
UL 60950
UL 2043
CSA C22.2 No. 60950
IEC 60950
EN 60950
Cisco Aironet 1300 Series Wireless Outdoor Access Point/Bridge Hardware Installation Guide
Power Injector and Power Module
—
—
—
Power injector:
UL 2043
Power injector and power module:
UL 60950
CSA C22.2 No. 60950
IEC 60950
EN 60950
The power injector and power module
Note
must be used in an indoor
environment.
C-3