Site Surveys; Unpacking The Access Point/Bridge; Package Contents - Cisco AIR-BR1310G-A-K9 - Aironet 1310 Outdoor Access Point/Bridge Hardware Installation Manual

Site Surveys

Site Surveys
Every network application is a unique installation. Before installing multiple access point/bridges, you
should perform a site survey to determine the optimum use of networking components and to maximize
range, coverage, and network performance.
Consider the following operating and environmental conditions when performing a site survey:
•
•
•
•

Unpacking the Access Point/Bridge

Follow these steps to unpack the access point/bridge:
Open the shipping container and carefully remove the contents.
Step 1
Return all packing materials to the shipping container and save it.
Step 2
Ensure that all items listed in the
Step 3
is damaged or missing, notify your authorized Cisco sales representative.

Package Contents

Each access point/bridge package contains these items:
•
•
•
•
•
•
•
•
Cisco Aironet 1300 Series Wireless Outdoor Access Point/Bridge Hardware Installation Guide
2-6
Data rates—Sensitivity and range are inversely proportional to data bit rates. The maximum radio
range is achieved at the lowest workable data rate. A decrease in receiver sensitivity occurs as the
radio data increases.
Antenna type and placement—Proper antenna configuration is a critical factor in maximizing radio
range. As a general rule, range increases in proportion to antenna height. However, do not place the
antenna higher than necessary because the extra height also increases potential interference from
other unlicensed radio systems.
Physical environment—Clear or open areas provide better radio range than closed or filled areas.
Obstructions—Physical obstructions such as buildings, trees, or hills can hinder performance of
wireless devices. Avoid locating the devices in a location where there is an obstruction between the
sending and receiving antennas.
An access point/bridge unit (model: AIR-BR1310G or AIR-LAP1310G)
– Integrated antenna or external antenna configuration
Power injector (LR2) unit
Power module and AC power cord
Quick start guide
Mounting instructions document
Read Me document
Translated safety warnings document
Cisco product registration and Cisco documentation feedback cards
"Package Contents" section are included in the shipment. If any item
Chapter 2 Installation Overview
OL-5048-06