Before Beginning The Installation - Cisco AIR-BR1310G-A-K9 - Aironet 1310 Outdoor Access Point/Bridge Hardware Installation Manual

Chapter 2 Installation Overview
The external antenna access point/bridge configuration does not ship with an external antenna. An
Note
external antenna must be purchased.
The optional roof mount kit contains these items:
•
•
•
•
•
•
•
•
•
The optional wall mount kit (for indoor use) contains these items:
•
•
The optional transportation power injector
•

Before Beginning the Installation

Before you begin the installation process, please carefully review the following list of figures to become
familiar with the system components, connectors, indicators, cables, system interconnection, and
grounding:
•
•
•
•
•
To meet regulatory restrictions, the external antenna access point/bridge unit and the external antenna
Note
must be professionally installed. The network administration or other IT professional responsible for
installing and configuring the unit is a suitable professional installer. Following installation, access to the
unit should be password-protected by the network administrator to maintain regulatory compliance.
OL-5048-06
One roof-wall mount
Two dual-coax cables [20 ft (6.1 m) and 50 ft (15.2 m)]
Multi-function mount (consisting of a access point/bridge bracket and a mast bracket)
Two tower clamps (U-bolts) with four nuts and washers
Four bolts and washers for securing the access point/bridge bracket to the mast bracket
Four bolts for securing the access point/bridge bracket to the unit
Grounding block and mounting screws
Ground lug for the access point/bridge, two hex nuts, and two washers
Weatherproofing kit (consisting of Coax Seal and electrical joint compound)
Wall mount bracket with 4 mounting bolts and washers
Two sub-mini RG-59 coax cables (12 in. or 30.5 cm)
Power injector (LR2T) unit
Installation diagram (Figure
Access point/bridge layout
Power injector layout (Figure
Power module (Figure 2-4)
Grounding block (Figure 2-5)
Cisco Aironet 1300 Series Wireless Outdoor Access Point/Bridge Hardware Installation Guide
2-1)
(Figure 2-2)
2-3)

Before Beginning the Installation

2-7