Table of Contents
Advertisement
Static IP Setting
Automatic Network Setting
Run the <IP Installer.exe>program and display the found SNT-1010 list on the screen.
Before You Start!
In the initial run, the [Auto Set] and [Manual Set] button are all disabled.
1
3
4
36
2
1
Select an SNT-1010 you want from the SNT-1010 list.
Confirm the MAC Address of the SNT-1010 on its rear panel.
The [Auto Set] and [Manual Set] button are activated.
2
Click the [Auto Set] button.
The Auto Set window appears.
The automatically found <IP Address>,
<Subnet Mask>and <Gate Way> are displayed.
3
If SNT-1010 is installed on an IP sharer,
you can use the UPNP Port Mapping
function.
4
Enter your password.
The password is the SNT-1010 login password of
the root user.
The default password is 4321.
5
Click the [OK] button.
The automatic network setting is finished.
6
SNT-1010 automatically restarts when the
network setting is complete.
Dynamic IP Setting
Dynamic IP Setting
Examples of using Dynamic IP
- If SNT-1010 is installed on an IP sharer and obtains an IP using DHCP
- If sNT-1010 is connected directly to a xDSL/Cable modem using DHCP
- If an IP is allocated by the internal DHCP server in local area networking
To set SNT-1010 to Dynamic IP mode
1.
Position the IP selection switch to D (Dynamic IP).
2.
Connect SNT-1010 to the IP sharer or modem using the Direct LAN
Cable (UTP cable).
SNT-1010 does not come with the Direct LAN cable.
You have to purchase it separately.
3.
Connect SNT-1010 to the power source.
4.
When SNT-1010 starts, it automatically obtains an IP address from
the IP sharer or modem.
5.
If you use an IP sharer, you can check the dynamic IP address from
the IP sharer by using the IP installer on your PC.
37
Advertisement
Table of Contents
