Table of Contents
Advertisement
Setting Up
Network Configuration
To set video streaming
You can control the data transfer rate according to the SNT-1010 video streaming type and network
bandwidth.
<Streaming Type> : You can select a protocol for video transmission from the <TCP>,
<UDP(Unicast)> and <UDP(Multicast)>.
- <TCP> : It is a general purpose protocol used for a transmission that requires reliability.
Since it provides a connectionbased communication between the sender and recipient, it provides high
reliability against transmission data loss.However, it is inappropriate to transmit a large amount of data
in real-time because of its transmission overhead. It enables reliable data transmission over ADSL and
cable network at a relatively slow speed.
- <UDP> : It is a protocol appropriate to transmit a large amount of data such as multimedia data in short time.
However, it provides higher transmission efficiency than TCP especially over high speed connections
faster than 100Mbps.
- <Unicast> : It refers to transmitting data to only one receiver (1:1).
- <Multicast> : It refers to the data transfer protocol in one-to-many (1:N) between the transmitting and receiving
terminals.Although it alleviates the network load, it requires <Multicast> router.
For more information such as whether the network over which the SNT-1010 is installed supports
<Multicast>, ask your network administrator.
<Streaming Control> : You need to set the bandwidth to an appropriate value according to
the data rate of your network for smooth video streaming.
- You can set the <Bandwidth> by selecting one from <Unlimited/5Mbps/3Mbps/1Mbps/600Kbps/300kbps/150Kbps>.
- If your network provides data rate equal to or higher than 100Mbps, it is recommended to set the <Bandwidth> to <Unlimited>
or <5Mbps>. If you are using a broadband Internet connection, set the <Bandwidth> to <3Mbps> or <1Mbps>.
- If you are using an ADSL or normal low speed DSL network, set the <Bandwidth> to <600Kbps> or lower for
smooth video streaming.
- The maximum number of images per second in the video setting menu is automatically determined depending
on the selected <Bandwidth> value.
Page 50
76
Click <NETWORK>
<STREAMING SETUP>.
The STREAMING SETUP window
appears.
To complete the setting, click the
[Apply] button.
The settings are saved.
To set IP address automatic notification
If the SNT-1010 is set to <Dynamic IP>, you can have the automatically allocated IP
address sent to an FTP or e-mail. This function is executed only when the settings and
test on the FTP/E-mail (SMTP) of the <EVENT> are done.
Click <NETWORK>
<IP
NOTIFICATION>.
The IP NOTIFICATION window
appears.
To complete the setting, click the
[Apply] button.
The settings are saved.
Page 68~69
77
Advertisement
Table of Contents
