Table of Contents
Advertisement
Network Connection & Setup
Connect SNT-1010 to an IP sharer with local area networking
[ STEP 4 ] To connect a local PC in the IP sharer to SNT-1010
1
Run the IP Installer on your local PC and search for SNT-1010.
2
If found, double-click the SNT-1010 to start the Internet browser and try to connect to
SNT-1010. Alternately, launch the Internet browser manually and enter the IP address of the
SNT-1010 found in the address bar to connect to it.
ex) http://192.168.1.2
28
(Continued)
[ STEP 5 ] To connect to SNT-1010 from an IP sharer external PC
1
An IP sharer external PC can't use the IP Installer to search for an IP sharer internal
SNT-1010 This is because the IP Installer does not work in a network where the gateway is
different.
2
In this case, you can use the DDNS URL of SNT-1010 or the Internet IP address of the IP
sharer to connect to the IP sharer internal SNT-1010.
3
However, you must set the port-forwarding for the IP sharer before you can connect to the IP
sharer internal SNT-1010 from a remote PC.
For more information on the port-forwarding, refer to Use IP Sharer: Port Forwarding Setting
(Port Mapping).
4
When the port forwarding is done, run the Internet browser on the IP Sharer External PC and
enter the DDNS URL address or, the Internet IP address of the IP sharer in the address bar
for connecting to SNT-1010.
ex) http://mfffe42.websamsung.net
For the DDNS URL address, refer to "To check the DDNS address" on page 41.
A remote PC in an external Internet out of the LAN network may not be able to connect to SNT-1010 installed
Note
in the intranet if the port-forwarding is not properly set or a firewall is set. In this case, to resolve the problem,
contact your network administrator.
29
Advertisement
Table of Contents
