Network Connection And Setup; Connecting The Network Video - Samsung SPE-400 User Manual

network connection and setup

You can set up the network settings according to your network configurations.
CONNECTING THE NETWORK VIDEO ENCODER DIRECTLY
TO LOCAL AREA NETWORKING
Connecting to the network video encoder from a local PC in the LAN
1. Launch an Internet browser on the local PC.
2. Enter the IP address of the network video encoder in the address bar of the browser.
Network Video Encoder
Network Video Encoder
Local PC
<Local Network>

M
A remote PC in an external Internet out of the LAN network may not be able to connect to the
network video encoder installed in the intranet if the port-forwarding is not properly set or a
firewall is set.
In this case, to resolve the problem, contact your network administrator.

In the IP installer, you can use the initial password, "4321" to set IP Address ,Subnet Mask,
Gateway, HTTP Port, VNP Port, IP type. After changing the network interface, for better security,
access the web viewer and change the password.

By factory default, the IP address will be assigned from the DHCP server automatically.
If there is no DHCP server available, the IP address will be set to 192.168.1.100~103(CH 1~CH 4).
To change the IP address, use the IP Installer.
For further details on IP Installer use, refer to "Static IP Setup". (Page 26)
INTERNET
Firewall
DDNS Server
(Data Center, KOREA)
External Remote PC
English _21