Table of Contents
Advertisement
By default, the video output is set to S-Video. But, you can choose one of the following
connections if you prefer:
S-Video:
DVI
VGA:
Component:
Composite:
Click the Show IP button shown below. The IP address appears on-screen momentarily
then disappears after about four seconds. If the IP address does not appear, check that
the NMP-500 and the display are set to the same video output settings: i.e., S-Video to
S-Video, or VGA to VGA, etc. To change the output setting, login to the NMP-500 (Step 3)
and select Management > Video/Audio for the screen shown below. For more
information, see the Video/Audio Configuration section later in this guide.
Show IP
ViewSonic NMP-500
Default. Connect an S-Video cable from the S-Video interface on the
back of the NMP-500 to the S-Video interface on the back of the display.
Connect a DVI cable from the back of the NMP-500 to the DVI interface
on the back of the display.
Using the DVI-VGA adapter included, connect a VGA cable from the VGA
interface on the back of the NMP-500 to the VGA interface on the back of the
display (PDP or LCD). Note: do not use both a VGA connection and a YPbPr
connection at the same time.
Using the S-Video/YPbPr adapter.
Using an RCA cable.
8 of 38
Advertisement
Table of Contents
