Front Usb Connector Assembly - IBM 84875MU User Manual

7. Use a flat-blade screwdriver to press up on the lower tab of the control panel
8. Press together the two latches at the top of the assembly until it detaches from
To install the control panel assembly, reverse the previous steps, making sure to
route the cables carefully and snap the operator information panel into place.

Front USB connector assembly

Note:
Complete the following steps to remove the front USB connector assembly:
1. Turn off the server and attached devices; then, disconnect all power cords and
2. Remove the cover and support bracket (see"Removing the side cover" on page
3. Remove the front bezel (see "Removing the bezel" on page 27).
4. Rotate the drive cage up.
5. Disconnect the front USB connector assembly cable from the system board.
64
xSeries 206 Type 8482 and 8487: Hardware Maintenance Manual and Troubleshooting Guide
Note: The illustrations in this document might differ slightly from your hardware.
assembly until the bottom of the assembly detaches from the chassis.
the chassis; then, pull the control panel assembly out of the chassis through the
front, making sure that the cables follow freely.
Important: When removing the assembly, note the routing of the cables
through the aperture in the chassis. You must route the cables
through this aperture upon reinstallation to avoid damage to the
cables when the drive cage is in the closed position.
v Read "Installation guidelines" on page 23.
v Read the safety notices at "Safety information" on page 107.
v Read "Handling static-sensitive devices" on page 24.
external cables.
26 and "Removing and installing the support bracket" on page 28).
Attention: Do not place any strain on the hard disk drive cables; it might be
necessary to disconnect these cables before pivoting the drive cage.