IBM 84875MU User Manual page 44

10. If you are installing a 5.25-in. drive in bay 2, push the drive into the bay. If you
11. Determine whether the drive is an IDE or SCSI device; then, connect one end
12. Route the signal cable so that it does not block the airflow to the rear of the
13. If you have another drive to install or remove, do so now.
14. Connect the power cable to the back of the drive. The connectors are keyed
34
xSeries 206 Type 8482 and 8487: Hardware Maintenance Manual and Troubleshooting Guide
7. Touch the static-protective package containing the drive to any unpainted metal
surface on the server; then, remove the drive from the package and place it on
a static-protective surface.
8. Set any jumpers or switches on the drive according to the documentation that
comes with the drive.
Note: You might find it easier to install the new drive from the front, and then
attach the cables.
9. Remove the clip from the side of the drive cage of bays 1 and 2. Slide the clip
to the left to remove it from the drive cage; then, snap the clip into the screw
holes on the side of the drive (the blue side of the clip should be facing
outward).
are installing a 3.5-in. drive in bay 2, you must attach the 5.25-in. conversion
kit, available separately, to the 3.5-in. drive.
Note: Only a 3.5-in. device can be installed in bay 4.
of the applicable signal cable into the back of the drive and make sure that the
other end of this cable is connected into the applicable IDE or SCSI connector
on the system board.
drives or over the microprocessor and memory.
and can be inserted only one way.
Drive clip
EMC shield
Filler panel