HP Integrity rx1620 Software Manual page 93

• V — View mode configuration (text, keyword, hex)
• ? — Display this help menu
• Q — Quit
SMCLP — Server Management Command Line Protocol (rx2660, rx3600, rx6600, BL860c, and
BL870c only). This command switches the console terminal from the MP Main Menu to the Server
Management Command Line Protocol (SMASH) SM CLP interface.
CLP offers the following features:
• Is a user-friendly method to view and manage server information
• Can be used in addition to the existing MP command-line interface (CLI)
• Is available from any text user interface (serial, telnet, and SSH)
• Creates CLP sessions that are independent from each other and are not mirrored
• Provides a subset of MP CLI commands
• Provides access to the MP Main Menu interface and the system console interface
For detailed information about SMASH CLP usage, see:
http://docs.hp.com/en/5971-4292/ch11.html
SO — Configures security options and access control (users, passwords, and so on). This command
modifies the security parameters of the MP, which include login timeouts and allowed password
faults.
If configured, when you access the MP through the modem port, the MP hangs up and dials you
back. This does not work if Modem Presence is set to not always connected with the CA command.
If the mode is single, the state is changed to disabled after the first login. A user whose login is
disabled is not accepted.
SS — Displays the status of the system processors. The SS command displays the status of the
system processors and which processor is the monarch.
SYSREV — Displays the revision status of firmware in the system.
TC — System resets through INIT or Transfer of Control (TOC) signal. Shut down the OS before
issuing this command.
This command causes the system to be reset through the INIT or TOC signal. Execution of this
command irrecoverably halts all system processing and I/O activity and restarts the computer
system. It is different from the RS command in that the processors are signaled to dump state
on the way down.
TE — Tell. Sends a message to other terminals. You can enter up to 80 characters. The message
is broadcast to the other mirrored clients. Users in a session or CSP are not shown the message.
UC — User Configuration. Controls user access. Use this command to add, modify, re-enable, or
delete user logins. You can also enable or disable security warnings and change passwords.
VFP — Displays Virtual Front Panel. The VFP command presents a summary of the system by
using direct console addressing. If the terminal is not recognized by the MP, VFP mode is rejected.
Each individual user gets this summary to avoid issues related to terminal type and screen display
mode.
WHO — Displays a list of MP connected users. This command displays the login name and
operating mode (Main Menu, command, and so on) of the connected console client users, and
the port on which they are connected. For the LAN and WEB console clients, the command also
displays the remote IP address.
If the local console client user did not originate the MP command interface session, there is always
one default user listed for the local serial port: local user i. If the local console operator enters
CTRL+B, then the login name that the local operator used displays instead.
X — Exits MP command interface and disconnect from the system. This command disconnects
the executing user from the system. This command is available from the local port.
Management processor 93