Installing Partition Management Tools; Snmp Traps Tab; Snmp Service Configuration - HP Integrity rx1620 Software Manual

3. From the list of services, double-click SNMP Service. The SNMP Service Properties (Local
Computer) window appears.
4. Click the Security tab.
5. Click the Traps tab.
Figure 3-12 SNMP traps tab
6. In the Community name field, if a community name already exists, select it. If one does not
exist, enter a community name and click Add to List.
NOTE:
different community string here, enter the same string on the management console that is
responsible for the system. HP recommends not using the string public because it is the
default value, commonly used, and can present a security risk.
7. Under the Traps Destinations list, click Add. The SNMP Service Configuration window
appears.
Figure 3-13 SNMP service configuration
8. In the Host name, IP or IPX Address field, enter the IP address of the management console.
This address identifies the management console to receive the alert when the server agents
detect a significant event.
9. Add 127.0.0.1 as a trap destination if it is not already listed. You must do this to enable the
loopback service.
10. Click Add, then OK.

Installing partition management tools

This section is an overview of the installation and use of the nPartition Commands Bundle and
nPartition Manager Bundle. You must install the nPartition Commands Bundle before the
66 Installing the Management Tools
The default community string for HP Insight Manager is public. If you enter a