HP Integrity rx1620 Software Manual page 91

DI — Disconnects remote/modem or LAN/WEB console. This command disconnects (hangs up)
the remote/modem or LAN/WEB users from the MP. It does not disable the ports. The remote
console is no longer mirrored.
FW — Activates MP firmware upgrade mode. This command is available from either the LAN
or a local serial port. This command activates firmware upgrade mode, which loads new firmware
through the MP LAN by FTP (which must be operational). An MP reset is generated after the
upgrade is complete.
HE — Displays help for menu or command. This command displays the MP hardware and
firmware version identity, and the date and time of firmware generation. If executed from the
MP Main Menu, this command displays general information about the MP and those commands
displayed in the MP Main Menu. If executed in command mode, this command displays a list
of command interface commands available to you. It also displays detailed help information in
response to a topic or command at the help prompt.
ID — Displays and modifies system information.
This command enables you to display and modify the following:
• SNMP contact information
• SNMP server information
• SPU host name
IT — Inactivity Timeout settings. The session inactivity timeout is up to 1,440 minutes — the
default is 60 minutes. This timeout prevents sessions from being inadvertently left open. You
can start a session with the SE command. An open session can prevent users from logging into
the MP through a port and can also prevent system applications from initiating an outbound
connection.
The MP inactivity timeout is up to 1,440 minutes — the default is 5 minutes. This timeout prevents
a user from inadvertently keeping the MP locked in an MP command interface mode, and
preventing other users from looking at the console output. You cannot deactivate the MP
command interface inactivity timeout
The flow control timeout is 0 to 60 minutes. If set to 0, no timeout is applied. This timeout prevents
mirrored flow control from blocking other ports when inactive.
LC — LAN configuration (IP address and so on). This command displays and allows modification
of the LAN configuration. Configurable parameters include the following:
• MP IP address
• MP host name
• Subnet mask
• Gateway address
• Web console port number
• Link state
The MP host name set in this command is displayed at the MP command interface prompt.
Typically you enter the DNS name for the LAN IP. You can program this field to any useful
name or phrase. For clarity, it is useful to enter MP-on-SYSTEM as the MP host name, so both
names show up in the prompt (limit 19 characters, no spaces allowed.) Use this command to also
set the web access port number.
LA — LAN Status. This command displays all parameters and the current status of the MP LAN
connections. The LAN parameters are not modified by the execution of this command.
LOC — Locator LED Status. This command displays the current status of the locator LED.
MA — Returns to the MP Main Menu. This command makes the MP return to the nonmirrored
MP Main Menu. This is the same as executing CTRL+B.
MR — Modem Reset. This command makes the MP send an AT Z command to the modem, which
resets it. Any modem connections are lost. You can view the initialization results using the MS
command.
MS — Modem Status. Displays modem status. The MS command displays the state of the modem
lines connected to the remote/modem serial port. Update the display by pressing Enter. This
Management processor 91