Programming The Remote Control; Testing The Remote Control - Toshiba DW65X91 Owner's Manual

USING THE REMOTE
PROGRAMMING THE REMOTE
CONTROL
The universal remote can be programmed to control most brands of remote
controllable components such as VCRs. The remote is already programmed
to control most TOSHIBA TVs, VCRs, and DVD players.

Testing the Remote Control

To determine whether the universal remote control requires programming,
turn on a component, such as a VCR, point the remote control at the VCR,
and set the component (TV/DVD/VCR/CABLE) switch to "VCR". Then
press POWER or CH yz to see if the VCR responds to the remote control
commands. If not, it requires programming.

Programming the Remote Control

1. Refer to the "VCR code table", 'DVD code table" or "Cable TV
converter code table" on pages 26 and 27 to find the code number that
corresponds to the brand name of your component.
If more than one number is listed, try each one separately until you find
the one that works.
2. Set the component switch to "VCR", "DVD" or "CABLE" position.
3. While holding down EXIT, press the Number buttons to enter the three
digit code number for your brand of component. The transmit indicator
lights up for 1 second when the programming is completed.
When an operation error has occurred, the indicator blinks.
Press EXIT again to reset.
4. Point the Remote Control at the component and press POWER to test
the code number.
– If the number is correct, the component should turn on.
– If the component does not respond to the remote control, repeat steps
1 through 4 with another code number.
• You have to reprogram the remote control when you change its batteries.
• Some newer VCRs are capable of working on either of two remote
codes. These VCRs have a switch labeled "VCR 1/VCR 2."
If your VCR has this kind of switch, and does not respond to any of the
code numbers for your VCR brand name, set the switch to the other
position ("VCR 1" or "VCR 2") and reprogram the remote control.
• In some rare cases, you may not be able to operate your non-TOSHIBA
equipment with the supplied remote control. This is because your
equipment may use a code that is not provided with this remote control.
In this case, please use the equipment's own remote control.
24
LEARN/
TV/VIDEO TV/SAT POWER
TV
DVD
VCR
REW RLAY
CABLE
SWAP SOURCE
Component
TV/VCR PAUSE STOP
switch
STILL
ANTENNA
O K
( ENTER )
MENU
REC RETURN
MUTE
CH VOL
PIC SIZE
A B 1 2
4 5
C D
7 8
E F
OK 0
G H
+100 / ENTER
USE LEARN
For future reference, write the code number
you set.
DVD CODE: _______________________
VCR CODE: ________________________
CABLE CODE: _____________________
Transmit
indicator
POWER
FWD
POP
SLOW
EXIT
EXIT
CHyz
3
6
Number
9
buttons