Programming The Remote Control; To Program The Remote Control - Toshiba ColorStream TP50G60 Owner's Manual

I _ INTRODUCTION
Programming the Remote
Control
,!,
TV/CABLE/
VCR switch
- CABLE MUTE W/VIDEO TIMER
®@@
FAVY FAVA
STOP SOURCE PLAY PiP
C?K3
TOSHIBA
-- RECALL
POWER
-- Number
buttons
For future reference,_rite the code
number you set.
VCR CODE:
CABLE CODE:
Note:
You have to reprogram the Remote
Control when you change its batteries.
• This Remote Control is programmed to operate TOSHIBA VCRs.
• To operate VCRs (or Cable converters) other than TOSHIBA models,
perform the following procedures before operating.
Refer to the "VCR code table" (or "Cable TV converter code table_)
on pages 16 and 17 to find the code number that corresponds to the
brand name of your VCR (or your converter).
If more than one number is listed, try each one separately until you
find the one that works.
Set the TV/CABLE/VCR switch to "VCR" (or "CABLE").
While holding down RECALL, press the Number buttons to enter
the three digit code number for your brand of VCR (or converter).
4
Point the Remote Control at the VCR (or at the converter) and press
POWER to test the code number.
--If the number is correct, the VCR should turn on.
--If the VCR does not respond to the Remote Control, repeat steps
1 through 4 with another code number.
Notes:
• Some newer VCRs are capable of working on either of two remote
codes. These VCRs have a switch labeled "VCR 1NCR 2."
If your VCR has this kind of switch, and does not respond to any of
the code numbers for your VCR brand name, set the switch to the
other position ("VCR 1" or "VCR 2") and reprogram the Remote
Control.
• In some rare cases, you may not be able to operate your non-
TOSHIBA equipment with the supplied Remote Control. This is
because your equipment may use a code that is not provided with
this Remote Control. In this case, please use the equipment's own
remote control.
15